> News > Industry News

Industry News

How to repair the computer board of the injection molding machine

To repair a relatively unfamiliar circuit board of an injection molding machine without any principle, the so-called "experience" in the past is difficult to make a difference.

How to solve the problem of heating of injection molding machine?

How to solve the problem of heating of injection molding machine? 1.Causes of heating of injection molding machine; 2.Harm of high temperature rise of high speed injection molding machine; 3.Cooling method of injection molding machine.

How to solve the problem of injection molding short shot?

The factors affecting the melt flow length include: part wall thickness, mold temperature, injection pressure, melt temperature and material composition. If these factors are not handled well, they will cause short note.

Three advantage of servo in injection molding machine

During the molding process of the injection molding machine, different frequency outputs are produced for different pressure flows,and the pressure flow is accurately closed-loop controlled to realize the servo motor.

Causes of common injection molding defects and solutions.

Burr is caused by the overflow of molten injection resin from the parting surface of the mold, which is a bad state in the forming operation. Especially when the burr is firmly adhered to the parting surface of the die for die locking, it will damage the parting surface of the die.

How to maintain injection molding machine in daily life?

Possible faults of injection molding machine. Failure cause of die locking structure and prevention of hinge fracture. Excessive clamping force、Poor operation 、Insufficient lubrication、Poor design

<...10 11 12 13 14...17 >